Accessories for the Pro Control
®
G3:
Order these accessories from your Tri-Tronics dealer, on our web site,
or by calling us at 1-800-456-4343:
•
Extension cord for receiver
•
Transmitter holster
Please note you may order a separate receiver or transmitter for your
Pro Control
®
G3 system at any time. Factory matching of components
is not needed because the Pro Control
®
G3 is field-expandable!
Detailed Instructions
Transmitter Dial
The transmitter has ten dial positions and “N,” which inactivates all transmitter
buttons. Each numbered dial position controls a different receiver. It is possible to
operate up to 10 Pro Control receivers with one Pro Control
®
G3 transmitter. When
using several training devices, move the transmitter dial to the next device to be
activated, then activate it with the appropriate transmitter button.
Receiver Jacks
The receiver has two output jacks so you can operate two launchers, bird releasers, or
other compatible training devices from each receiver. One jack is on the left side of the
receiver; the other is on the right side. (Left and right as you hold the receiver with
the antenna pointing up and the control switches facing you.) The location of the
left jack corresponds exactly to the location of the output jack on our older 150
System receivers, so the Pro Control
®
G3 receiver should be physically compatible
with any training device you have operated with a 150 System.
Test Switch
Pressing the TEST switch on the receiver will cause the lights next to the words
“left” and “right” to light up when a device is plugged into the corresponding jack.
Pressing the TEST button will not activate training devices.
Transmitter Buttons
The upper button, marked “S,” operates the receiver sound. The middle button,
marked “L,” operates the device plugged into the left output jack. The lower but-
ton, marked “R,” operates what you have plugged into the right output jack.
Sound
The speaker on the receiver makes a loud sound that can be used to attract a
retriever's attention to a mark or to help the trainer locate a launcher hidden in
heavy cover. When a very loud sound is desired for training retrievers at field trial
distances, place the receiver in a way that orients the speaker toward the “line.” For
more about the sound feature, see “Sound Selection.”
CAUTION: The speaker is very loud – do not operate it close to a person
unless you place something over the speaker to muffle the sound.
Turning the Receiver On and Off
Press the on/off switch on the receiver to turn it on. The red light on the receiver
will light up when the receiver has been turned on, and then blink twice every four
seconds (if it flashes rapidly, this means the receiver battery is low).
Press the on/off switch to turn the receiver off – the red light will make one long
flash then go dark, confirming that the receiver is off.
When not using thesystem,turnthe receiver off to save battery life.
Setting the Receiver to the Transmitter
Before you can use a Pro Control
®
G3 receiver for the first time, you must set it to
operate with your transmitter.
If you have several receivers, set each one to a different transmitter dial number.
Follow these steps to set the receiver to match a particular number on the
transmitter dial.
(8 Seiten)
(15 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern